Home > Grass Resource > How to Install Artificial Grass > Garden Grass Installation

Grass Installation

Knowing how to install artificial grass is important to achieve the best results.With our Luxgrass artificial grass ,you can have a lush ,green grass without worrying about the maintenance.If you do with to do a DIY installation for your LuxGrass, see our guide below for how to get the best look out of your new artificial turf.

Grass Installation

Materials You Need

Before you begin installing artificial turf, make sure you have all the supplies you need:

● Artificial turf

● Utility knife

● Rake or shovel

● Tape measure

● Wide shop push broom

● Stamper

● Sand infill with a minimum of 30 grit

● Seaming tape and adhesive

Step 1: Prepare the base 

Most outdoor applications require preparation of an aggregate base to allow proper water drainage. Simply clear the surface where your artificial grass will be placed, removing any unwanted grass and roots.

Prepare the base

Step 2: Compacting base

Once clear, add a two to four-inch layer of crushed aggregate until achieving the desired shape and contour. Work the aggregate with a rake and hand tamp until the surface is compact and smooth.

 Compacting base

Step 3. Apply drainage membran

Once the base is compacted, apply drainage membrane to the area . Trim off any waste membrane from the edges.Secure seams with U-nails to secure a-joining sections of the membrane. Apply as necessary to anchor the membrane and prevent movement when laying the synthetic lawn.

Apply drainage membran

Step 4 .Unroll the artificial turf over the area and trimming 

being careful to not move the weed membrane. Running the product toward the house will give the best look from the windows of the house. Once positioned, trim the excess artificial grass. Edging gives you a useful edge to run your knife around. 

Unroll the artificial turf over the area and trimming

Step 5. Glue together seams 

To seam artificial turf together, align two pieces of LuxGrass edge-to-edge. Fold back the edges to lay artificial grass seaming cloth the length of the seam and then brush the glue. 

Glue together seams

Step 6. Secure in place 

To secure your LuxGrass, use five to six-inch galvanized nails or landscape anchor pinsaround the perimeter and where necessary to keep your Grass flat.

Secure in place

Step 7. Infill the sand and Brush grass 

Every square meter grass infill about 5 kg silica sand.

Finally. Use a landscape rake or broom to brush the fibers up and rinse with a garden hose. Periodic brushing and rinsing will keep your grass looking fresh, natural and beautiful for years to come.

Infill the sand and Brush grass

Previous: None

Next: None

Evergreen Resource Limited

+86 20 2981 4866

+86 20 2981 4866



Address: 1227 Room, No.1 Building, Xiajiao Commerical Building, Luopu Street, Panyu District, Guangzhou, China

Copyright © Evergreen Resource Limited All Rights Reserved

Sitemap   |    Powered by

chat online LuxGrass-china